Elaxen PN

Injection Protocol

Instruction

• Ensure the packaging is intact and undamaged.
• Check the expiration date to ensure product safety.
• Check the syringe markings to confirm the correct dosage.
• Carefully screw the needle or cannula onto the syringe. Ensure a secure fit.
• Hold the syringe firmly and remove the protective cap from the needle end.

Work Protocol

Step 1: Prepare Skin for the Procedure

1. Anesthetize the skin with anesthetic cream in preparation for treatment.

2. Remove the anesthetic cream and clean with alcohol swab the injection area.

Step 2: Administer the Recommended Course for Redermalization

1. Make injections superficial (1-2 mm deep) with a 4-mm needle.

2. Injections should be given at a 45-degree angle from the skin while applying light, constant positive pressure on the plunger; the practitioner rapidly flicks the wrist.

3. At each site, introduce a drop of 0.005-0.01 ml of the solution.

Step 3: Post-Injection Care

1. After completing the procedure, use alcohol for skin cleansing.

2. Apply a small amount of alcohol on a sterile cotton pad.

3. Gently cleanse the treated area with the cotton pad, ensuring thorough coverage.

4. Pay special attention to areas where the injection was performed.

Photo-aging protection: Use SPF 50 UVA and UVB protection to guard against hyperpigmentation, especially useful for damaged skin

Course of Procedures:

The course of procedures is 4-6 with an interval of 7-14 days. Repeat course after 6 months

Note: Adherence to aseptic techniques, safety guidelines, and proper equipment sterilization are crucial during the procedure. The provided product amounts are recommended for a face, neck, and décolleté procedure. Follow the outlined course with the specified intervals, and repeat as advised for optimal results. Adjust the dose per injection based on the specific technique employed during the procedure.